Dynon Avionics SkyView HDX Series, Maintenance Manual, Page: 83 / 128

SkyView HDX System General Maintenance Manual, Revision F Page | 83
8.4.1 Location
Primary display is typically located on left instrument panel; secondary display is typically located
on right instrument panel. For specific location, see the
Equipment Installation Record document
associated with the airplane.
8.4.2 Removal
1. Shut down airplane power.
2. Remove screws that secure the SkyView HDX Display to instrument panel. Keep screws
for re-installation .
3. Slide SkyView HDX Display out of instrument panel to expose backside of unit and gain
access to connectors.
4. Disconnect all cables and D37 and D9 electrical connectors from back of unit. This is
accomplished by removing two retention screws on both D37 and D9 electrical
connectors.
8.4.3 Installation
1. Connect D37 and D9 electrical connectors and all cables to back of unit.
2. Slide SkyView HDX Display back into instrument panel.
3. Reinstall screws that secure unit to instrument panel (see Table 11 : Replacement
Hardware if screws need to be replaced).
4. If all other removed system components are installed, reconnect battery and provide
power to SkyView HDX Display and other system components.
5. Make sure SkyView HDX Display powers up normally and no unexpected messages
appear. If an issue occurs, see Section 7.2 .