Page | 112
SkyView
HDX System
General Maintenance Manual, Revision F
8.23.3
Installation
1. Connect electrical connector to button.
2. Install button in same location on instrument panel using same screws (see
if screws need to be replaced).
3. Restore power to airplane.
4. Turn SkyView system
ON
.
5. On SkyView HDX Display, verify the AP DISCONNECT message is not displayed. If it is,
8.24
Yoke-Mount Autopilot Disconnect Button
An Autopilot Disconnect (A/P DISC) button is required if SkyView Autopilot is installed. The
button can be mounted on the instrument panel or affixed to the control yoke by a shop-
manufactured bracket.
8.24.1
Location
The pilot’s control yoke, as shown below:
Figure 76: Example of Autopilot Disconnect Yoke Button
8.24.2
Removal
1. Shut down airplane power.
2. Remove button from yoke bracket by removing retaining nut. Keep retaining nut for re-
installation.
3. Remove button and disconnect electrical connector from button.
8.24.3
Installation
1. Connect electrical connector to button.
2. Install button in same location on yoke bracket using retaining nut
(
contact button
manufacturer if retaining nut need to be replaced).
3. Restore power to airplane.
4. Turn SkyView system
ON
.
5. On SkyView HDX Display, verify the AP DISCONNECT message is not displayed. If it is,