Dynojet Dynoware RT, Installation Manual, Page: 20 / 88

C H A P T E R 2
Remove the DynoWare EX Electronics
DynoWare RT Upgrade for Model 424x Dynamometers Installation Guide
2-6
R
EMOVING THE
P
ICKUP
C
ARD
, B
RACKET
,
AND
C
ABLE
Use the following instructions to remove the pickup card, bracket, and cable from both
the above and in ground dynos. Be sure to remove the pickup card, bracket, and cable
from the stationary and 4WD dyno.
1 Release the dyno brake using the red button on the pendant.
2 Rotate each drum until the pickup tab is aligned with the pickup card.
3 Set the brake and turn the dyno electronics off.
Note: You must line the pickup tab with the pickup card before removing the
Breakout board. The drum will not rotate once the Breakout board is removed.
4 Mark the position of the bracket. The new pickup card bracket must line up with
the position of the existing bracket. Be sure to mark both the stationary and 4WD
dyno bracket location.
5 Remove the two screws securing the bracket and set aside.
6 Remove the bracket.
Figure 2-3: Removing the Pickup Card Bracket
mark bracket position
mark bracket position