L I N X W I T H A T R A F L E X I N S T A L L A T I O N
Unpacking the Linx Parts
Linx with Atra Flex Installation for Model 424 Automotive Dynamometers
4
UNPACKING THE LINX PARTS
Use the following steps to unload your Linx system parts.
1
Using a pry bar, or a large flat screwdriver, and a hammer, carefully remove the
top and sides of the crate. At this point, you will want to inspect the exterior of the
dyno for any indications of damage. Report any damage immediately.
2
Remove the following parts from the crate and set aside.
part
description
part
description
stationary pulley mounting
plate
P/N 21200083
tensioner assembly
P/N 61100008
movable pulley mounting
plate
P/N 21200090
upper stationary pulley
mount
P/N 61300022
stamped 1
idler pulley mounting plate
P/N 21200091
lower stationary pulley
mount (3)
P/N 61300023
stamped 2
flange bearing with lock
collar (6)
P/N 32300001
inner stationary dyno
mounting plate
P/N 61300024
bushing (2)
includes three bolts and
washers per bushing
P/N 32300002
upper movable pulley
mount
P/N 61300025
stamped 3
grooved pulley (2)
P/N 32300003
lower movable pulley mount
P/N 61300026
stamped 4
outer carrier bearing,
bore (2)
P/N 32300009
inner movable dyno
mounting plate
P/N 61300027
