Center column
Hanging hook
Monopod leg
V1 ENGLISH 14-0371
Storing your tripod
1
Remove your camera.
2
Loosen the center column locks. Raise the column as far as it
will go, then tighten the bottom lock. Lower the top section as
far as it will go.
3
Twist each leg lock counterclockwise and collapse the legs.
4
Wrap your hand around all four leg locks, then twist clockwise
to tighten them all at once.
5
Pull out the leg release tabs and flip the legs up.
Note
: You may need to rotate the head slightly so the legs fit between
the knobs.
6
Store the tripod into the carrying case.
Important safety instructions
• Make sure that all leg locks are correctly tightened and that the
legs are fully opened before use.
• Do not carry or transport your tripod with camera equipment
attached (for example, over your shoulder or cradled in your
arms).
• Do not expose your tripod to excessive heat or cold, or use near
any flame or fire.
• Do not oil or grease any part of the tripod.
• Do not use any solvents or thinners to clean your tripod. Use
only a mild detergent and wipe dry with a soft, lint-free cloth.
• Do not exceed the load limit of this tripod.
Specifications
• Maximum operating height: 57.1 in. (145 cm)
• Minimum operating height: 6.7 in. (17 cm)
• Folded height (reversed legs): 13.4 in. (34 cm)
• Net weight: 2.7 lbs (1.24 kg)
• Max operating load: 8.8 lb (4 kg)
• Number of leg sections: 5
• Quick release thread: 1/4 in. (0.6 cm)
• Panoramic angle: horizontal: 360° and vertical: 90°
• Material: aluminum alloy
One-year limited warranty
Visit www.dynexproducts.com for details.
Contact Dynex:
For customer service, call 800-305-2204 (U.S. and Canada) or
01-800-926-3020 (Mexico)
www.dynexproducts.com
DYNEX is a registered trademark of BBY Solutions, Inc.
Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2014 BBY Solutions, Inc. All Rights Reserved.
QUICK SETUP GUIDE
DX-TRPMN57
57" Compact
Tripod-Monopod Combo
Before using your new product, please read
these instructions to prevent any damage.
Converting to a monopod
1
Holding the tripod firmly, unscrew the monopod leg from the
main tripod assembly.
2
Unscrew the center column locking screws, unscrew the bottom
hanging hook, then remove the center column from the tripod
base.
3
Screw the center column (with ball head) into the monopod leg.
4
To adjust the height, unscrew the leg twist locks, extend the leg
to the height you want, then tighten the leg locks.