Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc. Even with the application of the
relevant safety regulations and the imple-
mentation of safety devices, certain
residual risks can not be avoided. These
include:
•
Injuries caused by touching any
rotating/moving parts.
•
Injuries caused when attaching the
tool to the Power Unit.
•
Injuries caused by prolonged use of a
tool. When using any tool for pro-
longed periods ensure you take
regular breaks.
•
Injuries caused by external parts or
appliances when operating the tool.
When using the tool be aware of
external rotating/moving parts to
avoid injury.
FEATURES
This tool includes the following features:
1. Base plate
2. Fork shaft / shaft bit
3. Guide pins
Other references:
4. Cargo strap (not included)
5. Power Unit (not included)
USE
WARNING!
The Power Units
torque and speed control must
be set to the lowest until you
are familiar with the function of the tool. It
may cause risk of injury if highest speed
and torque are used.
WARNING!
Do not use the tool for other
than its intended use. Other usage can
cause personal injury and damage.
Attaching/removing the tool
•
Open the chuck on the Power Unit
(5). The chuck must fit with a mini-
mum Ø10mm shaft bit.
•
Insert the shaft bit (2) into the chuck,
and tighten the chuck properly.
•
To remove the tool, untighten the
chuck on the Power Unit and remove
the tool.
Insert strap and rewinding
(Fig. A
-
B
-
C
-
D)
•
Insert strap (4) between guide pins (3)
and next into fork shaft (2) (Fig. A &
Fig. B).
•
Hold and control the tool during
winding with your free hand (Fig. C &
Fig. D).
•
Control speed of rewinding with the
adjustable switch on the Power Unit.
To stop winding, release the switch.
•
When the strap is wound to the end,
immediately release the switch.
Removing a strap
•
First, remove the strap from the guide
pins.
•
Second, pull off the strap from the fork
shaft.
MAINTENANCE
•
Regularly oil the joint between the
base plate (1) and the fork shaft (2).
•
Keep the tool free from water if not
used for a longer period of time.
PROTECTING THE
ENVIRONMENT
Should you find one day that your Dynello
product needs replacement, or if it is of no
further use to you, do not dispose of it with
household waste. Make this product
available for separate collection.
Separate collection of used
products and packaging allows
materials to be recycled and
used again.
4
ENGLISH
(ORIGINAL INSTRUCTIONS)
