INSTRUCTIONS: IN-3000 Cod: DYN 26.0
6
Date: 2
0
/
10
/20
20
Revision: 0
6
4
Figure 4: Improper assembly
3.2 SAFETY GEAR ADJUSTMENT
⚠
In order to avoid problems with the installation’s normal operation, it is very important that the person
carrying out the installation rigorously observes the distances mentioned in this item.
3.2.1 IN-3000 MODEL FOR 8mm and 9mm THICKNESS GUIDE RAILS
The guide rail's position in the block should be adjusted as follows. (see drawing DYN 26.C02.00).
Figure 5: Safety gear adjustment in relation to the guide rail (IN-3000)
3.2.2 IN-3000 MODEL FOR 10mm THICKNESS GUIDE RAILS
The guide rail's position in the block should be adjusted as follows. (see drawing DYN 26/3.C02.00)
Figure 6: Safety gear adjustment in relation to the guide rail (IN-3000 G10)
3.3 COUPLING THE DRIVING BAR
It is the responsibility of the person who installs the safety gear to properly position the driving bar in relation
to the safety gear, as well as to properly synchronise the safety gears controlled by that driving bar. The correct
position is when the safety gear roller is on the bottom of the block.
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the
customer area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/
Summary of Contents for IN-3000
Page 2: ......
