Dynapac F1250CS, Application, Operation & Maintenance

Page: 221 / 348

D 40.12 11
After starting
m Let the paver finisher warm up for approx. 5 minutes if the engine is cold.
Observe indicator lamps
The following indicator lamps must be observed under all circumstances:
For other possible errors, see engine's operating instructions.
Battery charge indicator (1)
Must go out after starting.
m If the lamp does not go out or lights up during operation: Briefly rev up the engine.
A
The engine speed can be increased by switching on a conveying function.
Switch off the engine and determine the fault if the lamp does not go out.
For further possible malfunctions, refer to the section “Malfunctions”.
Oil pressure indicator lamp for the diesel engine (2)
Must go out after starting.
m If the lamp does not go out or lights up during operation:
Switch off the engine, check the engine oil level.
For other possible errors, see engine's operating instructions.
Hydraulic oil temperature (3)
When the hydraulic oil is cold:
- Switch conveyor (4) and auger (5) to "MANUAL" operating mode.
- Allow the function for increasing the hydraulic oil temperature to run until the lamp
goes out.