Dynapac F1000T, Operation & Maintenance Manual

Page: 128 / 238

D 3.0 8
D_3.0_
01_U
S.fm 8
-
8
Conveyor limit sensors
The ultrasonic conveyor limit sensors
control the material flow at the respec-
tive conveyor half. The conveyors
should stop when the material has
roughly reached the area below the au-
ger tube.
NOTE:
This requires that the auger height has
been adjusted correctly (see chapter E).
Ultrasonic auger limit sensors (left
and right)
The limit sensors control the material
flow at the respective auger half.
The ultrasonic sensor is mounted to the
side plate. Loose clamping lever for ad-
justment and modify angle / height of the
sensor.
The cables must be connected to the re-
mote control units located at the sides of
the screed.
NOTE:
Adjust the limit sensor positions while the material is distributed.
Sockets 24V
Connect the working lights (24 V) or oth-
er devices here.
- Power is present when the main switch
is switched on.
NOTE:
As an option, one socket can be used to
provide power for accessories.
Sensor
Sensor
Sockets