Dynapac DRP20, Operating Instructions Manual

Page: 60 / 112

7.1 Loading the machine
Loads must only be attached and hoisted by an expert / qualified
person.
Do not use damaged or in any other way impaired lifting points.
Use only lifting and lashing tackle with sufficient load bearing
capacity for the weight to be loaded. Minimum load bearing
capacity of lifting tackle: see operating weight
Ä
Chapter 2 „Tech-
nical data“ on page 11 .
Always use appropriate lifting and lashing tackle on the lifting and
lashing points.
Use lifting tackle only in the prescribed direction of load application.
Lifting tackle must not be damaged by machine components.
When lifting the machine, avoid uncontrolled movements of the
load. If necessary, hold the load with guide ropes.
Protective equipment: n Protective gloves
1. Park the machine in secured condition
Ä
Chapter 6.4
„Parking the machine in secured condition“ on page 57 .
2. Allow the engine to cool down.
3. Remove the transport wheels from the base plate.
4. Move the steering rod to an upright position and engage the
locking pawl lever.
5. Attach the lifting tackle to the designated lifting eye (1).
6.
DANGER!
Danger to life caused by suspended
loads!
– Do not step or stand under suspended
loads.
Lift the machine carefully and lower it again at the intended
location.
Fig. 42
Fig. 43
A Machine with engine protection
cover
B Machine with full engine protec-
tion hood (optional equipment)
Loading / transporting the machine – Loading the machine
DRP20 60