Dynapac DRP15X, Operating Instruction

Page: 93 / 112

8.10 As required
8.10.1 Cleaning the water spraying system
1. Park the machine safely
Ä
Chapter 6.5 „Parking the machine
in secured condition“ on page 60 .
2. Remove the cap.
3. Remove the rubber caps from the spray tubes.
4. Switch on the water spraying system.
5. Let all water flow out.
6. Flush the water tank with a strong water jet, until all dirt has
run out.
7. Plug the rubber caps back on the spray tubes.
8. Switch the water spraying system off again.
9. Fill the water tank with clean water and close the cap.
8.10.2 Cleaning the cooling fins and the cooling air intake openings
How dirty the cooling fins and cooling air intake
openings are depends very much on the daily
operating conditions; clean daily if necessary.
NOTICE!
Danger of engine damage caused by reduced
cooling!
– For this reason you should always seal any oil
or fuel leaks in the vicinity of the cooling fan or
the coolers and clean the cooling fins after.
Water
B-692-0230
Fig. 110
B-692-0234
Fig. 111
Maintenance – As required
DRP15X 93