19
CA500 O500EN1
Engagement and disengagement of vibration is made
with the switch (19) on top of the forward/reverse lever.
Always switch off vibration before the roller comes to a
complete standstill.
Never allow vibration to be on when the roller
is stationary; this may damage the surface and
the machine.
VIBRATION/DRIVING
Drum vibration can be set in two modes, selected using
the switch (13). Turn the knob to the left mode for low
amplitude, to the right mode for high amplitude.
Never alter the amplitude setting while the
vibration is running. Switch vibration off first
and wait until it has ceased before altering the
amplitude.
Fig. 17 Instrument panel
13. Amplitude selector
19. Vibration ON/OFF
Low/High amplitude
– Setting
19
13
DRIVING ON DIFFICULT COURSES
If the machine is equipped with a 2-speed drum drive
and becomes bogged down, turn the knobs for driving
as follows.
If the drum spins, set the drum drive high and the rear
axle low.
If the rear tires spin, set the drum drive low and the
rear axle high.
Set the knobs to their initial positions when grip is res-
tored to the machine.
Fig. 18 Control panel
14. Speed selector, drum
15. Speed selector, rear axle
Drum drive (Optional)
14
15
Summary of Contents for CA500 Series
Page 2: ...19 ILF015WO1...
