4 Ports 11g Wireless ADSL2/2+ Router
54
4.3.1.1.5.1 Bridge Configuration Procedures
1.
From the Setup main page, click on
New Connection
.
2.
Enter a unique name for the Bridge connection in the
Name
field. The name must not have spaces and
cannot begin with numbers.
3.
At the Type field select
Bridge
. The Bridge connection setup page is displayed as shown below.
4.
The Network Address Translation (NAT) and the Firewall options are enabled by default. Leave these in
the default mode.
5. Under
Bridge Settings
, select the encapsulation type (LLC or VC).
Note:
If you are not sure just use the default mode.
6. Under
PVC Settings
, enter the values of VPI and VCI settings.
Note:
Your DSL service provider or your ISP will supply these.
7. Select
the
Quality of Service
(QOS); leave the default value if you are unsure or the ISP did not
provide this information.
8. Click
the
Apply
button to complete the connection setup. This will temporarily save this connection as
illustrated in figure below. A new link has been created for this connection in the left-hand column. You
can Apply/Delete/Cancel this connection using this screen.
9.
To make the change permanent, click on
Save All
.
10. To check on the status, click on
Status
(at the top of the page) and select
Connection Status
.
