1
Flush Universal Soundbar/Speaker Bracket Installation Directions
Shelf Mount Setup on Page 4
Mounting the Flush Universal Soundbar/Speaker Bracket correctly takes a lot of thought and a lot of planning. Please read the
directions thoroughly and plan out how the mount would be installed best for your use. Each Setup will be different and these
directions can not account for every situation. Failure to do so may result in Damage, Injury, or Death. Dynamic Mounting is not
responsible for any damage, injury, or death resulting from improper mounting or use of the Flush Soundbar/Speaker Bracket.
These instructions are only a guide and the consumer is responsible for correct and secure mounting. The person installing the mount
should be a competent person with experience mounting load bearing assemblies. For any questions or concerns, please contact
Dynamic Mounting at
The Flush Universal Soundbar/Speaker Bracket is rated for a max load of 40 LBS, the
max load rating of your mount or TV could be less, Do NOT exceed load rating of either.
Specifications
Handles Center Speakers or Soundbars up to 40 lbs attached to Most TV mounts thicker than 1.5”.
Works with tear drop or threaded holes spaced up to 33.6” apart.
Shipping Dimensions: 30” x 4” x 4”
Shipping Weight: 6.8 pounds Bracket Weight: 5.5 pounds
Consult your TV’s and TV Mount’s manual before mounting, it contains relevant information.
Tools Needed
3/8” and 7/16” box or open ended wrenchs. A ratcheting
socket wrench makes the job easier
Phillips Screw Driver
Tools Included (In the Plastic Bag)
1
1/16” Hex L-Key
4
Adhesive Backed Rubber Bumpers
Parts Included
2
Sandwich Support
2
Vertical Support
1
Horizontal Support
2
Speaker Tab
2
Depth Support (Greater than 2.4” Mount Thickness)
2
Slim Depth Support (1.5”-2.4” Mount Thickness)
Fasteners for Bracket (On the Bracket)
10 1/4" Nuts
6
1/4" Carriage Screws
4
#10 Nuts
4
#10 Carriage Screws
Fasteners for Attaching the Soundbar to the Bracket (In
the Plastic Bag)
2
#6 Hex Screw
2
#6 Flange Nut
2
1/4” x 3/4” Long Phillips Screw
2
M4 x 20mm Long Phillips Screw
2
M5 x 20mm Long Phillips Screw
2
M6 x 20mm Long Phillips Screw
4
Thin Plastic Spacers
8
Thick Plastic Spacers
2
#10 Washers
Helpful Notes
1.
The Flush Soundbar/Speaker Bracket is designed to attach a Soundbar or Speaker to the TV Mount above or below a TV attached
to a Dynamic Mount.
2.
The Bracket can be used without a TV mount, just attach directly to the back of the TV, we do not include those bolts.
3.
The Bracket can also be setup as a shelf above or below the TV. See Page 4
4.
It is designed to Sandwich between a TV and TV mount.
5.
The bracket comes assembled for minimum size and may have to be adjusted to fit your setup.
6.
It is recommended to layout the TV, Mount, Soundbar Bracket and Soundbar on the floor before drilling holes in the wall.
7.
Soundbar and Speaker are used interchangeably in our literature.
8.
If your TV has bump outs, spacers may be needed. (Some Spacers are included, may need more)
