INSTRUCTIONS
TMP-646 Telephone Transmit & Receive Patch
For Use With Sound Card or Tape Recorder
P/N 43933
FOR LEGAL USE ONLY
3-24-08
www.
DynaMetric
.com
Page 1 of 2
©DynaMetric 2001 Doc 43934
The TMP-646 Telephone Transmit & Receive Patch allows you to record and play back
to your telephone from your sound card or tape recorder.
•
Record telephone conversations
•
Record just your voice through your sound card (i.e. memos, repetitive, canned
announcements…)
•
Playback from your sound card over the phone (announcements, music, phone
conversations, etc.)
Installation is easy, and operation is automatic, with no switches. The TMP-646 is
compatible with analog and digital phones, and standard sound cards and tape
recorders. You can leave it connected to your phone since it does not interfere with
normal telephone operation. Will not record speakerphone.
The operation of the TMP-646 is completely automatic. Simply install it according to the
instructions below and operate your sound card controls as usual. Note: Make sure the
"Monitor" switch on your sound card software (if any) is set to OFF to avoid feedback.
Playback can be heard in your earphone and on the other end of the call.
To Install:
(See diagram)
1 Unplug headset (or handset) coil cord from the base of the telephone, and plug
the short modular cord from TMP-646 in its place.
2 Plug the headset coil cord into the modular jack on the TMP-646.
3 Insert the 3.5mm GREEN plug on the long cord into the speaker or headphone
jack on the sound card or recorder.
4 Insert the 3.5mm PINK plug on the long cord into the MIC jack on the sound card
or recorder.
5
Make sure "Monitor" switch (if any) in sound card software is set to OFF.
6
Operate your sound card and phone according to the applicable hardware and
software instructions for your system.
