717 SOUTH MYRTLE AVENUE • MONROVIA, CALIFORNIA 91016-3422
626-358-2559 • FAX 626-359-5701 • 800-525-6925
DynaMetric
INSTRUCTIONS
TMP-620X Telephone Transmit & Receive Patch
For Use With Sound Card or Tape Recorder
P/N 43527
FOR LEGAL USE ONLY
10-2-01
www.DynaMetric.com
Page 1 of 2
©DynaMetric 2001 Doc 43884
The TMP-620X Telephone Transmit & Receive Patch allows you to record and play
back to your telephone from your sound card or tape recorder.
•
Record telephone conversations
•
Record just your voice through your sound card (i.e. memos, repetitive, canned
announcements…)
•
Playback from your sound card over the phone (announcements, music, phone
conversations, etc.)
Installation is easy, and operation is automatic, with no switches. The TMP-620X is
compatible with analog and digital phones, and standard sound cards and tape
recorders. You can leave it connected to your phone since it does not interfere with
normal telephone operation.
The operation of the TMP-620X is completely automatic. Simply install it according to
the instructions below and operate your sound card controls as usual. Note: Make sure
the "Monitor" switch on your sound card software (if any) is set to OFF to avoid
feedback. Playback can be heard in your earphone and on the other end of the call.
To Install:
(See diagram)
1
Unplug headset (or handset) coil cord from the base of the telephone, and plug the
short modular cord from TMP-620X in its place.
2
Plug the headset coil cord into the modular jack on the TMP-620X.
3
Insert the 3.5mm stereo plug on long BLACK cord into the speaker or headphone
jack on the sound card or tape recorder.
4
Insert the 3.5mm mono plug on the long GREY cord into the MIC jack on the sound
card or tape recorder.
5
Make sure "Monitor" switch (if any) in sound card software is set to OFF.
6
Operate your sound card and phone according to the applicable hardware and
software instructions for your system.
