INSTRUCTIONS
TMP-620 Telephone Transmit Patch
with Sidetone Enhancement P/N 44320-4
FOR LEGAL USE ONLY
10-21-05
www.DynaMetric.com
Page 1 of 2
©DynaMetric 2001 Doc 43484
The TMP-620 Telephone Transmitter Patch lets you connect your computer soundcard to
your telephone. An additional feature of this device is enhanced sidetone on the handset
or headset. With the TMP-620 you can:
•
Record telephone conversations,
•
Record just your voice onto your soundcard (i.e., record repetitive, canned
announcements)
•
Playback from your soundcard over the phone (phone conversations, announcements,
music, etc.)
•
Or just use your phone normally,
- all with the same headset (or handset), without unplugging anything. The TMP-620 is
compatible with analog and digital phones and standard soundcards. You can leave it
connected to your phone, since it does not interfere with normal telephone operation.
The operation of the TMP-620 is completely automatic. Simply install it according to the
instructions below and operate your soundcard controls as usual. Note: Make sure the
"Monitor" switch on your soundcard software (if any) is set to OFF to avoid feedback.
Playback can be heard in your earphone and on the other end of the call.
To Install:
(See diagram on reverse side)
1.
Unplug headset (or handset) coil cord from the base of the telephone, and plug the
short modular cord from TMP-620 in its place.
2.
Plug the headset coil cord into the modular jack on the TMP-620.
3.
Insert the 3.5mm GREEN stereo plug into the speaker or headphone jack on the
soundcard.
4.
Insert the 3.5mm PINK stereo plug into the MIC jack on the soundcard.
5.
Make sure "Monitor" switch (if any) in soundcard software is set to off.
6.
Operate your soundcard and phone according to the applicable hardware and software
instructions for your system.
717 SOUTH MYRTLE AVENUE • MONROVIA, CALIFORNIA 91016-3422
626-358-2559 • FAX 626-359-5701 • 800-525-6925
DynaMetric
