Using The Controller
18
© 2012 DynaGen Technologies Inc.
TOUGH Series User Manual
3.2
Warnings, Failures and Events History
Warnings and Failures
Warnings and failures occur when certain parameters (fuel level, oil pressure, etc.) are outside of
specified limits. These settings can be set using the front panel or the PC Configurator. All warnings and
failures are recorded in the Events History section of the menu.
Events History
Every time an event of significance occurs, the time and date as well as a description of the event is
placed as an entry in the Events History. Examples of events are: 'Successful Start', 'Over Speed
Warning' or 'Low Oil Failure.'
To view the Events History :
1. Place the controller in OFF mode.
2. Press enter to bring up the Main Menu and then select Events History.
3. Press the up or down buttons to browse through the events.
4. Press enter to exit out of the Events History.
From this menu you can scroll up to 150 events using the up and down arrows. Keep in mind the events
are recorded in order so Event 1 is the most recent event and Event 150 is the oldest event.
NOTE
: If a new event is recorded and there are already 150 events in the history, the oldest
recorded event will be deleted.
Device Information
You can find out information about the controller by navigating to the 'Device Info.' menu. From inside this
menu you can see the following information.
FUNCTION
DESCRIPTION
About Controller
Gives the hardware version, software version and serial number.
Maintenance
Gives the amount of time remaining before maintenance is required.
If '----' is displayed maintenance is disabled. A negative number
indicates the amount of time since maintenance timer expired.
