8
USE R GUI DE
|
BL UE WAVE
®
A X -5 5 0
Figure 7.
Controller, Topside
Figure 8.
PLC Connector Pin Reference
Wiring and Connections
All the wire and cable connections are at the top side of the controller.
NOTE:
For convenience, the I/O Interface contains two chassis ground
connections that are in common with the earth connection of the power
plug. These are the only two connections that should be used to make
external connections to earth ground.
Power Input:
The power cord plugs in here. Only use the power cord
supplied by Dymax. The power cord supplied with the Controller is
specifically designed and certified to work with the Controller. The
Dymax supplied power cord contains a special ferrite at the plug end
which is required for proper operation of the Controller.
WARNING!
The BlueWave AX-550 is designed and
certified to operate with the Dymax supplied 10Amp, 18AWG,
3 conductor power cord with ferrite core. Do not use any
other non-standard power cord that does not have the same
current rating and does not have the correct ferrite core installed.
Power Switch:
Turns the unit on and off.
I/O Interface:
Reference connector pin-out on the back of the
controller (Figure 8). Provides for wiring of remote-control features
including footswitch, inhibit/interlock, PLC and status signals.
Note: I/O connector type Phoenix Contact, Combicon, 1790360
Power
Input
Power Switch
I/O Interface with Terminal Block
installed
