24
CHROMA
0 ~ 20
GAMMA
0 ~ 4
DNR
OFF, LOW, MID, HIGH
DIS
OFF, ON
3.10 PTZ Communication
Each PTZ camera must have a unique address (ID). The factory default setting is 1.
PTZ COMMUNICATION
$
PTZ ID : 0001
PROTOCOL : AUTO
BAUDRATE : 9600
PARITY : NONE
TERMINATION : OFF
SAVE AND EXIT(ESC TO CANCEL)
PTZ ID
1 ~ 3999
PROTOCOL
AUTO, F2/F2E, PELCO-PD
BAUDRATE
2400, 4800, 9600, 19200, 38400 bps
PARITY
NONE, EVEN, ODD
TERMINATION (RS-485)
OFF, ON
The device connected at end of the line, whether it is a PTZ camera or keyboard, must
have the cable for communication terminated by setting the appropriate DIP switch. If
the DIP switch is not set properly to the right ID, control signal errors may occur. The
total length of the cable for communication should not exceed 4,000 ft (1,200 m).