17
3.6 Tour
There are 8 programmable Tours. Each Tour consists of up to 40 Preset positions,
Patterns, Scans, or other Tours (second-level). Using second-level Tours, it can be
expanded to over 300 functions in a single Tour.
TOUR SETUP
NUMBER : 01
TITLE : T01
SCAN TYPE : NORMAL
SPEED : -- STEP
TOUR FUNCTION
SAVE AND EXIT(ESC TO CANCEL)
TOUR FUNCTION SETUP
(CTRL KEY)
DWELL : -- SEC
003 A04 --- --- ---
--- --- --- --- ---
--- --- P01 --- ---
--- T02 --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
EXIT(ESC TO EXIT)
---
Blank position
SCAN TYPE
NORMAL, VECTOR
DWELL
03 ~ 99 seconds
003
Preset (1 ~ 240)
A04
Auto Scan (1 ~ 8, 10 ~ 17)
P01
Pattern (1 ~ 8)
T02
Tour (1 ~ 8)
Follow the steps below to program the Tours:
1.
Press the MENU key to display the main menu on the monitor. Scroll to Tour and
press the Right key to enter the Tour menu.
2.
Select “NUMBER” and set the desired number by pressing the Right or Left key.
3.
Select “TOUR FUNCTION” and press the Right key to enter the Tour Function
Setup menu.
4.
Choose a blank position to be programmed by pressing the Up, Down, Right, or
Left key.
5.
To add a stored Preset, press the Tele or Wide key then the stored Preset number
displays.
6.
To place functions other than Preset, press the IRIS Open key to scroll for Tour,
Pattern, or Auto-Scan respectively.
7.
You can also overwrite the programmed number and remove a stored number
from the Tour, press the IRIS Open key until ‘---’ is displaying in the position.