DVS SpycerBox, Hardware Manual

Page: 48 / 62

5-12
SpycerBox Hardware Guide
5.5 Removal of the Faceplate
The faceplate of the system can be removed, for example, during trans-
ports. For this perform the following:
y
Lift the faceplate of the system (see section “Faceplate” on
page 2-6).
Beneath it you will see a cable with a jack connection that supplies the
DVS logo of the faceplate with power.
y
Unplug the jack connection.
y
Next hold tight the faceplate and remove the hinge wires as indi-
cated in the following figure:
Figure 5-5: Removing the hinge wires
Afterwards the faceplate can be taken off.
The system must be operated only with the faceplate in-
stalled.
To reassemble the faceplate reverse the above steps.
hinge wire
1 22