DVS SpycerBox, Hardware Manual

Page: 33 / 62

3-1
4
5
2
1
3
3
I
A
Installation
This chapter describes the installation of the SpycerBox. It is divided into
the setup of the system’s hardware and a note about how to connect it
to a network.
3.1 System Setup
This section describes the setup of the SpycerBox hardware. The system
must be installed properly before you can start working with it.
To install the hardware of the SpycerBox perform the following:
y
Unpack the SpycerBox and its accessories.
y
Place the SpycerBox on a firm, flat surface within reach of a power
outlet or mount it in a rack. For good air circulation and cooling
make sure the ventilation holes are not covered.
y
Connect at least the following computer peripherals:
– Mouse,
– keyboard and
– a monitor that is operable at a resolution of at least
1024 × 768 pixels (default manufacturing setting).
y
Connect any other peripheral computer equipment. For an over-
view of the panels and connectors at the system’s rear see section
“Overview of the Rear” on page 2-9.
y
Connect the power cable(s) to the system.
Please check your delivery and compare it with the delivery
note which has been included in the package on an extra sheet
of paper. In case of missing items, please contact your local
vendor or DVS immediately.
To make warranty claims you have to keep the original pack-
ing and use it in case of a return transportation.