DVS ProntoXway, Hardware Manual

Page: 39 / 78

3-1
4
5
2
1
3
3
I
A
Installation
This chapter describes the installation procedure of the ProntoXway
hardware. The system must be installed properly before you can start
working with it.
To install the hardware of the ProntoXway perform the following:
y
Unpack the ProntoXway and its accessories.
y
Place the ProntoXway on a firm, flat surface within reach of a
power outlet or mount it in a rack. For good air circulation and cool-
ing make sure the ventilation holes are not covered.
y
Connect at least the following computer peripherals:
– Mouse,
– keyboard and
– a monitor that is operable at a resolution of at least
1024 × 768 pixels (default manufacturing setting).
y
Connect any other peripheral computer and video equipment. For
an overview of the panels and connectors at the system’s rear see
section “Overview of the Rear” on page 2-10.
y
Connect the power cable(s) to the system.
The ProntoXway hardware is now properly installed and you can switch
on the system as described in section “Starting the System” on
page 4-1.
Please check your delivery and compare it with the delivery
note which has been included in the package on an extra sheet
of paper. In case of missing items, please contact your local
vendor or DVS immediately.
To make warranty claims you have to keep the original pack-
ing and use it in case of a return transportation.
The recommended resolution to run the ProntoXway
software is 1600 × 1200 pixels.