DVS Pronto2K, Hardware Manual

Page: 38 / 74

3-2
Pronto2K/ProntoHD Hardware Guide
! Connect the power cable(s) to the video system.
The system is now properly installed and you can switch on the video
system (see section “Starting the System” on page 4-2).
Pronto2K/ProntoHD delivered with 2 chassis:
If your Pronto2K/ProntoHD is delivered with two casings, you have
to set up the connections between the casings now:
! Connect the cables as shown in the figure below:
Figure 3-1: Connections for a Pronto2K/ProntoHD delivered with 2 chassis
The layout of the slot panel connector areas shown in the
figure above may differ from your Pronto2K/ProntoHD
hardware. But for an easy installation, the connectors to be
interconnected carry corresponding designations. There-
fore, ’CH A’ should be connected to ’CH A’ and ’CH B’ to
’CH B’.
With the connections between the two casings complete, you may
now connect the power cables to both casings of the video system.