Section3: Operating DVDO EDGE GREEN with Remote and Menus
59
Settings: Audio: Select Audio Output
Main Menu
->
Settings
->
Select Audio Output (Same as Remote Control “Audio Out Buttons”)
Decision Logic for Auto Select:
The table below shows the connector choice for audio when Auto Select is chosen.
Note: “EDID” is information about the capability of a display or AV Receiver that is automatically read by EDGE GREEN over the
HDMI or DVI cable.
Output Connector
Conditions
Video/Audio HDMI
Display has audio capability (reported via the EDID).
No AV Receiver connected to the Audio HDMI port, or an AV Receiver is connected but powered off.
Audio HDMI
AV Receiver with HDMI inputs is connected to the Audio HDMI port and powered on.
Optical
Display does not have audio capability (reported via the EDID).
No AV Receiver connected to the Audio HDMI port, or it is powered off.
If you are using an AV Receiver for processing audio, then you need to configure your receiver to accept audio from the input that is
connected to the DVDO EDGE GREEN. You need only do this once, because your DVDO EDGE GREEN will handle audio switching.
Auto Select
EDGE GREEN will automatically route
audio to an audio output. The choice of
output depends on what components are
connected to the outputs and powered.
Audio Out on Video HDMI
Use this setting if you want to send audio
to your video display to use its built in
audio.
Audio Out on Audio HDMI
Use this setting if you have an AV
Receiver that accepts HDMI and you
want to use it for processing audio.
Audio Out on Optical
Use this setting if you have an AV
Receiver that does not accept HDMI
inputs.
