DVC DigitEyes Series, Technical Manual, Page: 31 / 66

26
Note: The Reset input signal (pin 17) is brought out on both branches of the splitter cable. This
allows the generation of the Reset signal from the Frame Grabber OR an external source. Only
one source may drive the Reset input at any given time !
PIN SIGNAL NAME PIN SIGNAL NAME
1 20
2 21
3 22
4 23
5 24
6 25
7 26
8 27
9 28
10 29
11 30
12 31
13 32
14 33
15 34
16 GROUND 35 GROUND
17 RESET 36 +5VOLT AUX. POWER OUT
18 MODE CONTROL 0 (Or Offset Control) 37 MODE CONTROL 1 (Or Gain Control)
19 MODE CONTROL 2
Table 5-2
:
"Y" Cable:
Pinout of Remote box DB-37 connector (marked "R")
(2) The Digital Signals branch:
PIN SIGNAL NAME PIN SIGNAL NAME
1 PIXEL CLOCK (+) 20 PIXEL CLOCK (-)
2 LINE DATA VALID (+) 21 LINE DATA VALID (-)
3 FRAME DATA VALID (+) 22 FRAME DATA VALID (-)
4 COMPOSITE SYNC (+) 23 COMPOSITE SYNC (-)
5 FIELD INDEX (+) 24 FIELD INDEX (-)
6 VIDEO DB9 (+) (LSB FOR DVC-10) 25 VIDEO DB9 (-) (LSB FOR DVC-10)
7 VIDEO DB8 (+) 26 VIDEO DB8 (-)
8 VIDEO DB7 (+) (LSB FOR DVC-08) 27 VIDEO DB7 (-) (LSB FOR DVC-08)
9 VIDEO DB6 (+) 28 VIDEO DB6 (-)
10 VIDEO DB5 (+) 29 VIDEO DB5 (-)
11 VIDEO DB4 (+) 30 VIDEO DB4 (-)
12 VIDEO DB3 (+) 31 VIDEO DB3 (-)
13 VIDEO DB2 (+) 32 VIDEO DB2 (-)
14 VIDEO DB1 (+) 33 VIDEO DB1 (-)
15 VIDEO DB0 (+) MSB 34 VIDEO DB0 (-) MSB
16 GROUND 35 GROUND
17 RESET 36
18 37
19
Table 5-3
: "Y" cable: Pinout of Digital DB-37 connector (marked "D")