7
Disassembly and Disposal
7.1
Safety recommendations
DANGER!
Explosive atmosphere
The product is installed in potentially explosive
atmospheres. Disregarding the safety regulations
of there areas may cause death due to explo-
sion.
– Stop the system before carrying out any work.
– Disconnect the system from compressed air
and material supply system.
– Secure the system against being switched on
again.
– Relieve the lines.
– Check for an explosive atmosphere prior to
entering into a potentially explosive area.
– Observe all general safety instructions for
handling the total system.
WARNING!
Escaping material
Escaping compressed material can cause
serious injury.
Before carrying out any work:
– Switch off material supply system. Secure
against reconnection.
– Depressurize the lines.
– Switch off the mains disconnecting device on
the technology cabinet. Secure against recon-
nection.
Before carrying out any work:
– Wear the specified personal protective equip-
ment.
WARNING!
Danger of crushing from robot movements
Robots move at high speeds and high power. If
the robot catches hold of persons, it can cause
life-threatening injury or death.
– Make sure that no people are in the danger
zone of the robot during operation.
– Before carrying out any work:
Moving robots in maintenance position
Switch off the mains disconnecting device
on the technology cabinet.
Secure against reconnection.
WARNING!
Noise
If pressurized pneumatic lines under pressure
come off loose, it creates loud noises. This might
damage the hearing.
Before carrying out any work:
– Switch off the mains disconnecting device on
the technology cabinet. Secure against recon-
nection.
– Depressurize the lines.
– Wear ear protection.
7.2
Disassembling connections
Requirements:
Robot is in the maintenance position.
Material-carrying lines are purged.
Material supply system is switched off and
secured against reconnection.
Mains disconnecting device on the technology
cabinet is switched off. Secured against recon-
nection.
Atomizer has been disassembled.
Disconnecting the connections from atom-
izer, fluid plate and technology cabinet is
described in separate operating instructions
7.3
Disassembly
WARNING!
Danger of crushing from robot movements
Robots move at high speeds and high power. If
the robot catches hold of persons, it can cause
life-threatening injury or death.
– Make sure that no people are in the danger
zone of the robot during operation.
– Before carrying out any work:
Moving robots in maintenance position
Switch off the mains disconnecting device
on the technology cabinet.
Secure against reconnection.
Disassembly and Disposal
03/2019
Atomizer Connection EcoGun - MRS00004EN
17/24
