Setting the feed-dog
34
Service manual H867 Version 00.0 - 08/2013
9.1.3 Aligning the feed-dog carrier together with the stitch regulator
gear
If moving the feed-dog carrier does not suffice, the feed-dog carrier must
be aligned together with the stitch regulator gear.
Cover
• Tilt the upper section backwards
4.4.1 Access to the machine bottom section
Figure 24: Moving the feed-dog carrier cross-line to the sewing direction
Setting steps
Moving the feed-dog carrier cross-line to the sewing direction
1. Remove the tension spring (8) from the mounting bracket.
2. Loosen the connection to the tie rod using the screws (1).
3. Loosen the rear assembly frame screw (6).
4. Loosen the setscrews for the adjusting rings (2).
5. Move the feed-dog carrier cross-line to the sewing direction such that
the feed-dog is exactly in the center of the throat plate cut-out.
6. Push the adjusting rings (2) toward each other as far as they will go.
Important:
Make sure that the sliding shaft (3) is tightened by the
clamping rings.
7. Tighten the setscrews for the adjusting rings (2).
1
2
4
3
4
6
7
8
5
5
(1) - Tie rod connecting screws
(2) - Adjusting rings
(3) - Sliding shaft
(4) - Assembly frame
(5) - Plates
(6) - Assembly frame screw
(7) - Screw
(8) - Tension spring
Summary of Contents for M-TYPE H867
Page 1: ...H867 Service manual...
Page 91: ......
