Dürkopp Adler 806N-111, Operating Instructions Manual

Page: 89 / 162

Programming
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020 87
5.6.2 Activating Sewing without edge folding
In the Sewing without edge folding mode the machine only sews
–
the fold-
ing procedure is not performed. This mode can be used, for instance, for
testing a new seam program or performing a seam quality check.
The speed is also often reduced when using Sewing without edge folding
mode. The speed must be reduced separately (

p. 93 ).
To activate Sewing without edge folding:
1. Press the Sew without edge folding button .

The button is highlighted in green.

In the next sewing cycle the machine only sews and does not fold.

The button is also displayed on user interface 1.
2. Press the Sew without edge folding button again to deactivate
this mode.

The button is no longer highlighted in green.

The machine will resume folding in the next sewing cycle.
This setting is deleted after switching off the machine, after loading a dif-
ferent seam program or after an EMERGENCY STOP.
5.6.3 Switching the stroke position on/off
The stroke position is the clearance between the sewing foot and the
ssewing material. This clearance should be set to the optimum value so
that the sewing material is held on the sewing material support surface
when the thread is tightened. This results in a high quality seam.
Stroke position OFF
The sewing foot always remains at the same distance above the sewing
material. An adjustment to suit multi-layered material is not possible.
Stroke position ON
The sewing foot adjusts to suit the thickness of multi-layered sewing ma-
terial. A prerequisite is that the necessary information for this is stored in
the respective seam program (

Instructions for use DA-CAD )?
To switch the Stroke position on and off:
1. Press the Stroke position button .

The button is highlighted in green.

When sewing, the machine automatically adjusts the stroke position
according to the information in the seam program.