Dürkopp Adler 667 PREMIUM, Service Instructions Manual

Page: 113 / 150

Programming
Service Instructions 667 PREMIUM - 03.0 - 01/2018 111
14.11.1 Setting the All data (
All Data
) parameter
All data – i.e. parameter settings, programs, and calibration values – are
transfered to the USB key or the control.
To transfer all data:
1. Plug the USB key into the socket (1) on the control (2).
Fig. 71: Data Transfer submenu
2. Call up the
Service > Data Transfer > All Data
menu item.
3. Press the OK button to confirm the selection.
4. Use the ▲
/
▼ buttons to choose between the options
Load from USB
or
Store to USB
.
5. Press the OK button to confirm.

The following warning message appears:
Fig. 72: Data loss warning message
6. To cancel, press the ESC button; to continue, press the OK button.

The data transfer begins and a message appears, stating that the
USB key must not be removed:
(1) - Connection (2) - Control
①
②
+
All Data will lost
OK ESC
Erase USB-Stick