DURKOPP ADLER beisler 2112-5, Service Instructions Manual

Page: 53 / 104

Programming
Service Instructions 2112-5 - 00.0 - 02/2020 51
8.4.12 Running the clamp motor in continuous operation
For testing purposes, the clamp motor can be run in continuous operation
to check for constant machine movement.
To start the clamp motor in continuous operation:
1. Press the key.
2. Press the Diagnostics key.
3. Press the Clamp transport key.
4. Press the Clamp motor permanent test key.
5. Confirm the safety prompt.
6. Press the key.
7. The clamp motor runs in continuous operation.
To
exit continuous operation:
1. Press the STOP key.
8.4.13 Checking the thread trimmer
By entering the three-digit value, you can specify when the thread cutter
will be activated.
The input must be checked for a machine cycle and corrected if required.
To check the thread trimmer:
1. Press the key.
2. Press the Diagnostics key.
3. Press the Sewing motor key.
4. Press the Thread trimmer key.
5. To start or stop the machine cycle, press the key.