DURKOPP ADLER beisler 2112-5, Service Instructions Manual

Page: 48 / 104

Programming
46 Service Instructions 2112-5 - 00.0 - 02/2020
8.4.4 Submenu
Eprom sewing parameters
This function allows you to copy the factory-programmed, fixed seams
from the Eprom back to the seam program.
To copy the factory-programmed seams into the seam program:
1. Press the key.
2. Press the Init parameters key.
3. Press the Eprom sewing parameters key.
4. Enter seam number 01 using the numeric keypad.
Specifying the order of the seams
The settings refer to the selected seam program. The order for sewing
the seams can be set at will.
When the order has been set, existing seam numbers are overwritten or
new seam numbers are created.
To specify the order of the seams:
1. Press the key.
2. Press the key.
 The display shows the marking of the seam program and the seam
number:
Fig. 26: Specifying the order of the seams (1)
3. Use the cursor to mark the seam number you wish to change:
Fig. 27: Specifying the order of the seams (2)
4. Press the key.
 The
Overwrite
function opens.
5. Enter a new seam number using the numeric keypad:
Fig. 28: Specifying the order of the seams (3)