DURKOPP ADLER beisler 2112-5, Service Instructions Manual

Page: 29 / 104

Setting up the machine
Service Instructions 2112-5 - 00.0 - 02/2020 27
7.4 Adjusting the folder
7.4.1 Aligning the folder parallel to the clamp rail
Proper setting
The lowered folder must be absolutely parallel to and in slight contact with
the clamp rail along its entire length.
Fig. 15: Aligning the folder parallel to the clamp rail
To align the folder parallel to the clamp rail:
1. Move the main clamp into position.
To do so, use the input/output control functions
• Move the main clamp to the front stop point
• Lower the main clamp
2. Move the folder into position.
To do so, use the input/output control functions
• Rotate the folder
• Close the folder clamp
• Lower the folder
3. Check the alignment of the folder clamp (3) to the clamp rail (4).
4. Loosen the screw (1) if the folder clamp (3) and the clamp rail (4) are
not parallel to one another.
5. Rotate the bracket (2) of the folder clamp parallel to the clamp rail (4).
6. Tighten the screw (1).
(1) - Screw
(2) - Bracket
(3) - Folder clamp
(4) - Clamp rail
①
②
③
④