DURKOPP ADLER beisler 2112-5, Service Instructions Manual

Page: 16 / 104

Assembling and disassembling the cutter block
14 Service Instructions 2112-5 - 00.0 - 02/2020
4 Assembling and disassembling the cutter block
Fig. 4: Assembling and disassembling the cutter block
The cutters are integral to a block together with the pressure cylinder.
The cutter block for the left fly piece is attached to the pick-up plate
bracket with 2 mounting brackets (1) and (2).
The cutter blocks for the left and right trouser components are each
attached with a mounting bracket (3) to the bottom of the working plate.
To disassemble and assemble the cutter blocks:
1. Disconnect the compressed air supply.
2. Loosen the screws (4).
3. Tighten the new cutter block.
4. Restore the compressed air supply.
Order
Proceed by carrying out the following adjustment:
• Adjust the cutter position ( 
p. 31
)
WARNING
Risk of injury from sharp parts!
Cutting injuries may be sustained.
Switch off the machine before adjusting the cutter
settings.
NEVER reach into the cutters with your hands.
(1) - Bracket
(2) - Bracket
(3) - Bracket
(4) - Screws
④
④
④
① ② ③