DURKOPP ADLER 969 Classic, Service Instructions Manual

Page: 24 / 122

Working basis
22 Service Instructions 969 - 06.0 - 03/2019
3.5 Axial play for shafts running in plain bearings
Fig. 10: Axial play for shafts running in plain bearings
Shafts (2) running in plain bearings (1) are axially adjusted when the lever
(3) and the adjusting ring (4) touch the front face of the plain bearing (1).
Important
When setting components mounted on shafts running in plain bearings,
always ensure that the axial play of these shafts is as small as possible,
or
0 .
3.6 Locking the machine in place
Some settings allow for the sewing machine to be locked in place at the
setting position. To do this, the locking peg from the accessory pack is
inserted into a slot on the arm shaft crank, blocking the arm shaft.
There are 2 locking positions:
• Position 1: Loop stroke position
• 5 mm end in the large slot
• Setting the loop stroke and needle bar height
• Position 2: Handwheel zero position
• 3 mm end in the small slot
• Setting the handwheel position and checking the bottom dead
center for the needle bar
(1) - Plain bearing
(2) - Shaft
(3) - Lever
(4) - Adjusting ring
①
②
③
④