DURKOPP ADLER 911-211, Service Instructions Manual

Page: 109 / 200

Programming
Service Instructions 911-211 - 02.0 - 10/2016 108
Bobbin change without a request from the program
If you wish to independently insert a new bobbin without being requested
to do so by the program, e.g. when changing color, then you have to tap
the
Spulenwechsel (Bobbin Change) button on the start screen after
changing the bobbin to inform the program that a new bobbin has been in-
serted and that thread consumption should resume from the value corre-
sponding to the full bobbin capacity.
Updating the bobbin capacity
To update the bobbin capacity:
1. Tap the button Spulenwechsel (Bobbon Change) on the
start screen.

The counter for the bobbin capacity begins anew with a full bobbin.
6.8 Continuing a seam in Repair mode after an error
In Repair mode you can move to any desired point on the contour, e.g. in
order to continue the seam program from this position after an error has
occurred.
To continue a seam in Repair mode after an error:
1. Tap the button Reparaturmodus (Repair mode) on the
start screen.

The
Reparaturmodus (Repair mode)
window is displayed.
Fig. 92: Continuing a seam in Repair mode after an error
2. Use the Vor (Forwards) and Zurück (Back) buttons to move to the
point where sewing is to continue.
3. Tap the Weiternähen (Continue Sewing) button.

The program jumps back to the start screen and sewing of the seam
continues from the selected point.