Programming
Operating Instructions 911-210-10 - 00.0 - 06/2020
81
5.13.2 Adjusting the stroke position
To adjust the stroke position:
1.
In the menu item
Extras
>
Service
>
Multitest (Multi
test)
press the
Hublage einstellen (Set stroke
position)
option.
The following options are displayed:
Output elements
No.
Meaning
Y1
Foot mode
Y2
Hook cover
Y3
Needle cooling on
Y4
Right clamp
Y5
Left clamp
Y8
Stitch position optimization
Y9
Threading switch lamp on
Y10
Oil level indicator warning light on
Y25
Marking lamp 1 (Z)
Y26
Marking lamp 2 (Z)
Y27
Marking lamp 3 (Z)
Y28
Marking lamp 4 (Z)
WARNING
Risk of injury from sharp and moving parts!
Puncture or crushing possible.
Do not reach into the machine when setting the
stroke position.
Switch off the power to the drives when you wish to
test the freedom of motion of the sewing foot rod.
Symbol
Meaning
Perform a reference run
Check the movement
Switch between jumping foot and presser foot
Switch over the mode of operation
Summary of Contents for 911-210-3020-10
