DURKOPP ADLER 911-210-3020-10, Operating Instructions Manual

Page: 54 / 128

Programming
52 Operating Instructions 911-210-10 - 00.0 - 06/2020
Checking or changing the bobbin
To change or check the bobbin:
1. Press the Spulenwechsel (Bobbin change) button.

The display shows a prompt asking whether you wish to reset the
bobbin counter.
2. Press the JA (YES) button if you wish to change the bobbin.

The bobbin counter will be reset.
OR
3. Press the NEIN (NO) button if you merely wish to check the bobbin.

The bobbin counter will not be reset.
4. Remove the transfer plate.
5. Press the Einfädelmodus (Threading mode) button on the machine
head.

The hook cover opens.
6. Change or check the bobbin.
7. Press the Einfädelmodus (Threading mode) button on the machine
head.

The hook cover closes.
8. Press the pedal forwards.

The machine moves into the insertion position.
9. Insert the transfer plate.
10. Press the pedal or press the Weiternähen (Continue Sewing) button.

The machine moves to the sewing position.
11. Press the pedal or press the Weiternähen (Continue Sewing) button.

The sewing procedure is resumed.
5.9 Resetting the counter
Depending on the machine parameter settings, the counter counts
the sewn programs or seam sequences up or down. You can use the
Zähler-Reset (Reset Counter) button to reset the counter
to the start value (

p. 75 ).
To reset the counter:
1. Press the button Zähler-Reset (Reset Counter) on the
start screen.

The counter is reset to the value defined in the machine parameters.