DURKOPP ADLER 911-210-3020-10, Operating Instructions Manual

Page: 52 / 128

Programming
50 Operating Instructions 911-210-10 - 00.0 - 06/2020
5.8 Continuing a seam after an error
5.8.1 Continuing a seam in Repair mode after an error
In Repair mode you can move to any desired point on the contour, e.g. in
order to continue the seam program from this position after an error has
occurred.
To continue a seam in Repair mode after an error:
1. Press the button Reparaturmodus (Repair mode) on
the start screen.

The
Reparaturmodus (Repair mode)
window is displayed.
Fig. 33: Continuing a seam in Repair mode after an error
2. Use the Vor (Forwards) and Zurück (Back) buttons to move to
the point where sewing is to continue.
OR
3. Use the buttons Vor ++ (Forwards) and Zurück ++ (Back) to skip to
the beginning of the next or the beginning of the previous seam section.
4. Press the Weiternähen (Continue sewing) button.

The program jumps back to the start screen and sewing of the seam
continues from the selected point.