Programming
96
Service Instructions 878-M PREMIUM - 03.0 - 10/2019
17.8 Setting the parameter Setting the gap between the foot
and the feed dog (
FootZeroHeight
)
Here the gap between the foot and the feed dog can be adjusted.
1.
Call up the
Service > FootZeroHeight
menu item.
2.
Set the value within the range 0 – 100.
3.
Press the
OK
button to confirm the change.
4.
Check the gap between the foot and the feed dog.
5.
If the gap between the foot and the feed dog is not correct, adjust the
value accordingly.
17.9 Counter submenu
Use this menu item to view the readings of the various counters. They are
intended for information only – no settings can be made.
17.10 Reset data submenu
Use this submenu to reset the data of the machine. Various settings can
be made for resetting the data. The options are explained in more detail in
the table.
Access is possible only by entering the password 25483 again.
The reset is carried out immediately after selecting a subitem with the
arrow buttons and then pressing OK. There is no further query, and there
is also no message stating that the reset was performed.
To reset the data:
1.
Select the
Reset
parameter.
2.
Press the
OK
button to confirm the selection.
Abbreviation
Meaning
P.C.
Piece Counter
The number of sewing items that the machine has sewn so far.
P.C.D.
Piece Counter Daily
The number of sewing items that the machine has sewn since the last
reset.
S.C.
The number of stitches that the machine has sewn so far.
B.C.
The number of stitches that have been sewn with the bobbin since the
last reset.
NOTICE
Property damage may occur!
Data and machine settings may be irretrievably lost.
Consider BEFORE the reset exactly which data need to be deleted.
Summary of Contents for 878-M PREMIUM
