DURKOPP ADLER 550-532, Instruction Manual

Page: 72 / 94

Settings via software (button feeder)
Instruction manual 550-532 - 00.0 - 07/2015 70
8.3 Setting button diameter and button height
Fig. 28: Button diameter
1. Make sure there is no button in either of the measuring
devices.
2. Press numeric key 1.
3. Insert a button into the measuring device (1) used to measure
the button diameter.
4. Press numeric key 2.
 The measured button diameter is indicated on the display.
 The button feeder duct opens.
5. Remove buttons that are not needed from the button feeder
duct.
6. Check the button diameter and press numeric key 2 again.
Fig. 29: Button height
7. Insert another button into the measuring device (2) used to
measure the button height, making sure the device can mea-
sure the entire height of the button (top side of the button
facing down).
(1) - Measurement of button diameter
①
(2) - Measurement - button height
②