DURKOPP ADLER 550-12-33, Operating Instructions Manual

Page: 81 / 200

Programming
Operating Instructions 550-12-33/34 - 00.0 - 08/2017 79
Removing a softkey function from the upper softkey
To remove the softkey function from the upper softkey:
1. Press the upper softkey (1) and button 6 at the same time.

The upper softkey (1) is no longer assigned a function.
5.4.2 Selecting a seam program in automatic mode
To select a seam program in automatic mode:
1. Use
◄
/
►
to switch to the selection.
2. Use
▲
/
▼
to select the seam program number 001 or another
one (if available).
The seam program number must not be 000 , as this number
signifies manual mode rather than a seam program.

The control switches to automatic mode, and the display
switches to:
3. Adjust the parameters on the display if necessary (

p. 90 ).
Fig. 49: Selecting a seam program in automatic mode
Information
If you wish to execute the seam program of a left/right piece and
both pieces have already been created, select the desired piece
now:
4. Use
◄
/
►
to switch to the selection.
5. Use
▲
/
▼
to select the desired piece
L
/
R
.
L
= left piece
R
= right piece