DURKOPP ADLER 512/532, Operating Instructions Manual

Page: 47 / 100

Programming
Operating Instructions 512/532 - 05.0 - 04/2018 45
4.21 Externally editing seam appearances
Seam appearances can externally created and edited on a PC,
e.g. using MS Excel or a text editor.
Each line represents a stitch coordinate in the X and Y directions.
The seam appearance has a maximum size of 400 x 300 x 1/10 mm.
Negative values and comma-separated values must not be ente-
red.
Information
The operator does not need to perform any calculations in order
to center the seam appearance. The machine automatically cen-
ters the seam appearance in the middle of the sewing field. To
subsequently relocate the seam appearance, see chapter saving
seam appearances (

S. 38 ).
NOTICE
Property damage may occur!
Damage to the clamp if the sewing field size does not match
the clamp feet.
Check the clamping foot and adjust if necessary.