DURKOPP ADLER 512-211-01, Service Instructions Manual

Page: 53 / 82

Settings via software
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016 51
Editing a sewing pattern / contour test: Value 4
Fig. 30: Editing a sewing pattern
1. Press the +/- Function buttons to set value 4.
2. Press the Selection button.

The Program display shows a 1 for the first stitch; the Function dis-
play shows the value for the X-axis; the X-axis LED illuminates.
3. Press the +/- Function buttons to set the coordinates of the 1st stitch
for the X-axis.
4. Press the Selection button.

The Y-axis LED illuminates; the Function display shows the value
for the Y-axis.
5. Press the +/- Function buttons to set the coordinates of the 1st stitch
for the Y-axis.
6. Press the +/- Program buttons to select the next stitch.
7. Repeat steps 3 to 5 for all additional stitches.
8. Press the Ready button to save the edited sewing pattern.
9. Press the Reset button.

The LED in the button switches off.
10. Press the USB button.

The LED in the button switches off.
11.23Error messages
If an error occurs, the Error LED illuminates.
Error Description Possible cause Remedy
E 8 Error table data Unable to read the table
data
Save the table data
again.
E 1 0 Error sewing
pattern number The selected sewing pat-
tern is not saved in ROM or
is set to non-readable. The
sewing pattern is "0" Press the Reset button to
confirm the sewing pat-
tern number.
E 3 0 Error needle
bar position top The needle bar is not at the
top position Check the connections.
Turn the needle bar to
the top dead center posi-
tion.