DURAG D-R 290, Operating Manual

Page: 121 / 202

7 | Checking / setting parameters with D‑ESI 100
D-R 290 121
Left click on the in the device list on the device for which the time is to be synchron­
ised, on the device parameter
Click on the "S
ynchronise time
" button.
All parameters that are changed must then be permanently saved. For this, see (in the
D‑ESI 100Manual) Chapter " 6.5 Example: Save parameters [
}
110] ".
The detailed procedure for setting parameters is described in the D‑ESI 100Manual.
Example: Setting – DURAG – Modbus address
The available address range is from 1 to 247.
The default address is: 25 .
Comply with the Modbus rules for the use of addresses!
Setting path:
Sitemap > »Device (e.g. D‑R 290 ) > >
Common Parameters > Bus In­
formation > Modbus Address, Value >
Fig. 7.3: Setting DURAG − Modbus address
Setting DURAG − Modbus address in the device
Left click on "Device" in the sitemap.
Left click on for the desired device in the device list.
Under
Common parameters
in the list field, after
"Select Group"
set
"Bus
information
".
Left click on the "Edit" symbol in the
"Modbus address
“ line.
Using the number keys, correct the Modbus address there in the
"Value"
column.
Step 2
Step 3
synchronise time
7.3
Step 1
Step 2
Step 3
Step 4
Step 5