DURAG D-R 290, Operating Manual

Page: 119 / 202

7 | Checking / setting parameters with D‑ESI 100
D-R 290 119
Checking / setting parameters with D
‑
ESI 100
The procedures for setting parameters of the measuring head(s) using the software
D‑ESI 100 (optional ) are described in the following sections. If necessary at the start
of each description you will find a box "D‑ESI 100 setting path. It shows the path to the
relevant menu in the setting software where you can perform the listed checks/
settings.
D−ESI 100 help function
D‑ESI 100 is intuitive to use. It was therefore possible to do without an elaborate help
function. Instead of that, information is overlaid as so-called Quick Info [
}
196] .
Quick info provides information while you are working with the program and inputting
data.
Simply hover the cursor over a pictogram (provided with quick info) whose function
you would like to get information about (see below, left-hand image). All symbols and
pictograms are generally provided with quick info of this kind.
Table 7.1: D-ESI 100 quick info
Further information on topics such as inputting parameters can also be obtained as
quick info if you hover the cursor over an " symbol" (see above, right-hand im­
age). You can get additional descriptions if you hover the cursor over a " symbol".
If at any time the Quick Info is not displayed, left-click in a free area of the screen.
Then hover the cursor again over the place where you require information.
You can get information about the program (as otherwise under Help>Info or
Help>About program or similar) as Quick Info, if you hover the cursor over "version"in
the bottom right-hand corner of the window.
Fig. 7.1: Info about D−ESI 100
7
» Device
» Options
» Data log
» Login
7.1
Help
Program version