2-23
Chapter 2 Basic Operation
After adjustment, press the key [11]. The paper is
stitched and goes to the folding stopper.
• When stitching has been set to off, the paper
goes to the folding stopper without being
stitched.
• When side stitching, corner stitching and
folding off have been selected, the paper is
ejected to the paper receiver.
Fine adjustments can be performed only within the range of ±5 mm/0.20 inch after size change.
If the paper size entered and that actually used differ by more than 5 mm/0.20 inch, you may
not be able to adjust precisely. Depending on the paper size, adjustment even within the range
of ±5 mm/0.20 inch may not be possible. In this case, enter the correct paper size again, and
perform the size change.
6-3. Adjusting the folding section (when “folding on” has been selected)
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
Adjust the position of the folding side guides using keys [1] to [4] and the folding back guides using the keys [6]
to [9].
Perform jogging using keys [5] and [10].
Adjust so that the guides touch the booklet edges lightly.
After adjustment, press the key [11]. The paper is folded and ejected, and the step mode ends.
When trimming is set to on using the trimming on/off key before starting the step mode, a booklet is
trimmed and ejected.
No.
Items
Function
[1]
Fine adjustment of folding side guide
The folding side guides move inward by about 1.0 mm/0.039 inch.
[2]
The folding side guides move outward by about 1.0 mm/0.039 inch.
[3]
The folding side guides move inward by about 0.20 mm/0.008 inch.
[4]
The folding side guides move outward by about 0.20 mm/0.008 inch.
[5]
Folding side guides operations
Activates the folding side guides once.
