ATT2100 TEMPERATURE TRANSMITTER
Operation Manual M2100-REV-G
6
1.2 Overview of Transmitter
Autrol® Smart Temperature Transmitter based in a microprocessor is the temperature transmitter, has
temperature sensors such as Thermocouple, RTD, mV, Resistance for temperature measurement.
ATT2100 has a true draft analog range from 0 to 20mA offering that feature that a temperature range or
after convert analog range to HART (Communication) digital signal transmit for control systems like DCS,
PLC. This Model has explosion protected type and high precision, better reliabilty and is available on
digital commuication for the use remotes communication system.
This transmitter is enabled in HART commmunication with Host, HHT (HART Hand-Held Terminal) or PC
Configurator. Thus, transmitter various variables in host is enable to be changed, configured and tested
calibrated by users. For the HART Communication between DC Power Supply and Transmitter has to
terminate 250~ 600 Ohm.
1.3 Software Compatibility
Autrol® Smart Transmitter's software is implemented and complemented if necssary. Uses of the
transmitter will not be a compatibility software is contained in the host of the HHT(Model 275 HART
Communicator). In this case contact us for software DD(Device Descriptor) to be able to use with the
transmitter, you must to use loading in HHT, etc.
There may be some differences on supported fucntions as to Firmware Revision of transmiter. This
manual is based on Firmware Revision 58. Function deviations as to firmware Revision are same as
under box
FUNCTION
Function Supports
ZERO / SPAN Botton
Autrol PC/PDA
HART 275/375
Before Rev. 58
Rev. 58
ZERO/SPAN
●
●
●
●
ZERO TRIM
●
●
●
●
ZERO Adj
●
●
●
●
Units set
ⅹ
●
●
●
Range set
ⅹ
●
●
●
Damping set
ⅹ
●
●
●
LCD Decimal set
ⅹ
●
●
∆
●
:
Supported.
ⅹ
:
Not Supported
∆
: Supported but update required
