H o w i t w o r k s (
cont.)
3
true Bypass footswitch
- Removes the circuit from your guitar’s signal via a hardwired
connection from the input jack to the output jack.
4
input Jack
- Plug in your guitar or another pedal cable here. If you want to use the
Resonance Switch, plug your guitar cable directly into the Pickup Booster.
5
output Jack
- Run a cable to the input of your amp or to the next pedal in your chain.
6
Power Jack
- We designed this pedal to be convenient. You can use any 9V to 18V
regulated DC adapter (negative polarity center terminal). When operating at higher
voltages, the gain remains the same but headroom is increased in proportion to the
voltage. Increased headroom lets you hit the pedal harder before clipping the pedal’s
internal circuitry.
7
easy access battery door (located on back panel)
- When the pedal is not in use, extend
your battery life by removing your guitar cable from the input jack.
L e t ’ s g e t s tA r t e D !
1. Start with the Gain control knob in the full counter-clockwise position (0dB), and the
Resonance Switch in the center (“0”) position. Set your amp level appropriately. Engage the
Pickup Booster by pressing the footswitch – the LED will come on when it’s active.
2. Rotate the Gain control knob clockwise until the desired amount of gain is achieved or keep
it at 0dB for a line drive effect.
3. Adjust The Resonance Switch according to your desired tone – only if the pedal is
directly connected to your guitar.
4. Rock out and enjoy. You have made a wise purchase.
